Dinzagarms.com

Phantom Flash Hider

Click the part # to add to cart

# PFH5028 - $30 - For 1/2-28 barrels - common for most AR's and a few AK's with 0.500" to 0.520" barrel o.d.'s

# PFH1410 - $30 - For 14x1 LH barrels - common for most AK's with 0.551" to 0.569" barrel o.d.'s. Threaded 5/8" deep.

# PFH14EXT - $40 - For 14x1 LH barrels - common for 7.62x39 & 5.45x39 Saiga and some newer .223 Saigas with 1" of muzzle and 0.551" to 0.569" barrel o.d.'s. Threaded 1" deep. You must cut the barrel shroud back flush with the front sight tower and thread the barrel.

# PFH14SAIGA - $50 - For 14x1 LH barrels w/1" of muzzle - common for 7.62x39 Saiga, 5.45X39 Saiga and some newer .223 Saigas with 0.551" to 0.569" barrel o.d.'s. These are threaded 1" deep then bored in the back to clear partially cut back FSB shrouds. You must cut the barrel shroud back to within 3/8" of the front sight tower and thread the barrel.

# PFH1510 - $40 - For 15x1 RH threaded barrels - Threaded 5/8" deep.

# PFH15EXT - $50 - For 15x1 RH barrels - common for .223 Saiga with 1" of muzzle and 0.591" barrel under FSB. Threaded 1" deep. You must cut the barrel shroud back flush with the front sight tower and thread the barrel.

# PFH15SAIGA - $55 - For 15x1 RH threaded barrels w/1" of muzzle - common for older .223 Saigas with 0.591" barrel o.d.'s. Threaded 1" deep then bored in the back to clear partially cut back FSB shrouds. You must cut the barrel shroud back to within 3/8" of the front sight tower and thread the barrel.

# PFH1575 - $50 - For 15x0.75 LH barrels - common for Saiga-410 shotgun

# PFH6324 - $40 - For 5/8-24 RH barrels - common for .308 Saiga with 0.631" barrel under FSB as well as AR-10 rifles.

# PFH1710 - $50 - For M17x1 RH barrels - common for .308 Saiga with 0.671" barrel under FSB or cut back barrels.

This phantom flash hider is safe for calibers up to 0.308". The Saiga 7.62x39 and .223 rifles have 1" of barrel out in front of the front sight block, so the noted hiders have been threaded deeper to account for this. Normally AK barrels stick out 9/16" in front of the FSB tower and the brakes are threaded 5/8" to 3/4" deep inside. *The Saiga-410 hiders are threaded to the correct depth for the factory config barrel threads.

These are marked "U.S.A." or "Made In USA" and count as a compliance part.

I recommend wrapping the barrel threads with teflon tape to index the brake. It's cheap and isn't affected by heat from normal firing.